![]() Connecting the meterbridge to a console is very easy and only requires plugging in the meterbridge harness and tightening the three 'grub' screws in the lower lip of the meterbridge. ![]() The meterbridge is available in various sizes to fit each console size and runs full length. Its purpose is to monitor the programme signal at the console main outputs i.e Groups 1 to 8, Left, Right and Mono. 1 B The meterbridge has been designed to compliment the Allen & Heath GL series of Live consoles. 3.) Plug in the meterbridge harness (D) into the connector marked METERPOD on the rear panel of the console. 2.) Once the meterbridge is in place, tighten the grub screws (B) to secure the meterbridge in place. Make sure all of the grub screws (B) are fully withdrawn from the meterpod extrusion (C) before fitting. Allen & Heath pioneered the concept of dual-function front-of-house and monitor mixers with the GL series. See if you are eligible to read or download our Allen Heath Gl. METERBRIDGE FITTING INSTRUCTIONS To fit the meterbridge: 1.) Carefully unpack the meterbridge and fit it over the console rear extrusion (A) as shown in fig 1.īlog Allen And Heath Gl 3200 Manual. AP2126 Issue 4 copyright © 2001 ALLEN & HEATH. ![]() ALLEN & HEATH Section A - 1 元dSM Publication.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |